forum

<r>I can confirm that the HRT4-ZW is working with Z-Cloud. I can read the current temperature and adjust the setpoint (or manually turn the heater on and off). Thanks Z-cloud!!<br/> <br/> I would like to be able to set the temperature in 0.5deg C increments in stead of 1 deg C increments, which shou...

<t>I understand the restriction in the GUI, the list of options would become very long as well.... but maybe it could be in 0.5C increments? BTW, how does Z-Cloud configure the values of parameters 1,2&3? (I mean what are the standard values assigned to this parameters by Z-Cloud?)<br/> <br/> <b...

Thanks a lot, this seems to be doable quite easily!

CSV is fine, I can easily import into any program and I can understand it's not included in Zcloud.

Again, thanks for your fast and comprehensive feedback, I can run off and apply this immediately, fantastic!

<t>How would I open/save a local file (from user's point of view) when all the code is executed on the remote Zcloud server?<br/> <br/> I seem to have to 0.5C thing in there using scenes, problem is the communication between Zcloud and the thermostat seem a bit dead... last contact on wednesday, whi...

<t>As far as I know, the HRT4 thermostat unit only has three paramters to set: <br/> 1 report temp, 2 celcius/fahrenheit, 3 sensitivity in 0.1 deg<br/> <br/> The thermostat USED to communicate with ZCloud, but the last communication now has been February 1st, as indicated by device status.<br/> Ther...

<t>Under Configuration - Wakeup Notification, I found:<br/> <br/> Wakeup time, seconds: 256 (256) [so actually set to 256]<br/> to Node: 'HRT4-ZW receiver' [OR] 'All nodes' <br/> <br/> I named the binary switch 'HRT4-ZW receiver' which is Node 2. It SEEMS I cannot select Node 1 here... is this a pro...

But my controller (Node1) still shows up with a "remote control icon" on the device configuration tab.

The stick has not been used (by me) with any other software, but I'm getting the feeling I got a used one!! :@

<t>I started using the automatic control for the thermostat using schedules, but the devices did not respond... Tried to rebuilt my network and re-include the HRT devices but seem to have screwed that up now :S Is it possible to reset ALL settings and pairings/inclusions etc and do a fresh start? <b...

Is there any way to update (change) the firmware of Z-wave devices such as the Duwi controller?
(I.E. how did you modify the Duwi controller... can it be flash over the air?)

Sensor does come up (room temperature) but I'm unable to change the thermostat setpoint (HRT4-ZW).

It does allow me to manually turn the heater on and off though!