Search found 3 matches

by joluzu
11 Jul 2018 07:50
Forum: Device specific
Topic: VISION In-Wall Dual Relay Switch ZL7432 status update problem
Replies: 1
Views: 697

Re: VISION In-Wall Dual Relay Switch ZL7432 status update problem

is somebody is interested I found the workaround:

basically when s2 is switched manually. the device send the status of the s1 to the controller. at that point you must update s2 getting the status update
by joluzu
06 Jul 2018 06:54
Forum: Device specific
Topic: VISION In-Wall Dual Relay Switch ZL7432 status update problem
Replies: 1
Views: 697

VISION In-Wall Dual Relay Switch ZL7432 status update problem

both relays works from the interface. but only sw1 update the GUI after a manual change.( sw2 don't update the GUI). in the device manual I found the reason : "For Wall SW1, ZL 7432 will report the status of On/OFF after doing “Association”. However, Wall SW2 will only report the status if Z-Wave™ I...
by joluzu
22 Aug 2015 10:31
Forum: RaZberry
Topic: z-wave.me command on Remotec ZXT-120 EU
Replies: 2
Views: 1761

Re: z-wave.me command on Remotec ZXT-120 EU

I'm in the same bote

in my case the zxt-120. is not responding to the configuration command 27 ( is not blinking after is send it)

did you find any solution?