is somebody is interested I found the workaround:
basically when s2 is switched manually. the device send the status of the s1 to the controller. at that point you must update s2 getting the status update
Search found 3 matches
- 11 Jul 2018 07:50
- Forum: Device specific
- Topic: VISION In-Wall Dual Relay Switch ZL7432 status update problem
- Replies: 1
- Views: 3985
- 06 Jul 2018 06:54
- Forum: Device specific
- Topic: VISION In-Wall Dual Relay Switch ZL7432 status update problem
- Replies: 1
- Views: 3985
VISION In-Wall Dual Relay Switch ZL7432 status update problem
both relays works from the interface. but only sw1 update the GUI after a manual change.( sw2 don't update the GUI). in the device manual I found the reason : "For Wall SW1, ZL 7432 will report the status of On/OFF after doing “Association”. However, Wall SW2 will only report the status if Z-Wa...
- 22 Aug 2015 10:31
- Forum: RaZberry
- Topic: z-wave.me command on Remotec ZXT-120 EU
- Replies: 2
- Views: 3874
Re: z-wave.me command on Remotec ZXT-120 EU
I'm in the same bote
in my case the zxt-120. is not responding to the configuration command 27 ( is not blinking after is send it)
did you find any solution?
in my case the zxt-120. is not responding to the configuration command 27 ( is not blinking after is send it)
did you find any solution?