Search found 6 matches

by splitfile
04 Aug 2019 01:53
Forum: Z-Uno
Topic: Hardware interrupt and zunoSendReport()
Replies: 7
Views: 650

Re: Hardware interrupt and zunoSendReport()

Hi and thank you. I'm not using "Serial" (only use it while debugging). However I have (after a lot of testing) come to the conclusion that the problem must be related to HW interrupts and zunoSendReport(). After I moved zunoSendReport() from the main loop to the HW interrupt function it is now work...
by splitfile
30 Jul 2019 01:46
Forum: Z-Uno
Topic: Hardware interrupt and zunoSendReport()
Replies: 7
Views: 650

Re: Hardware interrupt and zunoSendReport()

Hi again! After some more testing, it feels like it might be a software/interrupt issue. I tried the following. I put some adhesive tape over the IR sensor so that the hardware interrupt wouldn't trigger. Then I put all of it back in place, covering my power meter. Powering the Z-uno via USB (Output...
by splitfile
24 Jul 2019 21:47
Forum: Z-Uno
Topic: Hardware interrupt and zunoSendReport()
Replies: 7
Views: 650

Re: Hardware interrupt and zunoSendReport()

Hi and thanks for your reply. Would it be sufficient if I power the zuno via USB and use a 0.550 mA power supply? Keep in mind that it is the Zuno and one of these that I'm powering: https://www.mysensors.org/uploads/57c42093071cb0e34c90057e/image/light.jpg I'm also experimenting with the range betw...
by splitfile
23 Jul 2019 23:23
Forum: Z-Uno
Topic: Hardware interrupt and zunoSendReport()
Replies: 7
Views: 650

Hardware interrupt and zunoSendReport()

Hi, I'm experiencing some intermittent problem with my Zuno. Sometimes Zuno stops reporting my sensor values. I'm powering the Zuno via USB (output 1A). I have started to wonder if the problem has something to do with interrupts... I have an IR-sensor that counts the LED-blinks on my power-meter. Th...
by splitfile
17 Jul 2019 18:09
Forum: Z-Uno
Topic: Only get values from one channel (have two channels)
Replies: 4
Views: 264

Re: Only get values from one channel (have two channels)

Hi guys, Thanks for your response! I'm using Domoticz and a "Aeotec by Aeon Labs Z-Stick" -USB controller. I think I got it to work setting up the channels like this: ZUNO_SETUP_CHANNELS( ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_POWER, SENSOR_MULTILEVEL_SCALE_WATT, SENSOR_MULTILEVEL_SIZE_T...
by splitfile
11 Jul 2019 14:16
Forum: Z-Uno
Topic: Only get values from one channel (have two channels)
Replies: 4
Views: 264

Only get values from one channel (have two channels)

Hi, I'm trying to get the Zuno to work as a sensor with two channels. The sensor reports back power values. Watts and KWh (Kilo watt hours). The problem is that I seem to only get values on one channel. Maybe I'm not setting the channels up correctly? I read something about some issue if you have tw...