forum

That is not the latest which is why I asked back on the 30th. You need to use the token all to get the newer firmware update that has been out for quite sometime.

I have never had luck with security enabled in Aeotec products. They perform much better without security.

I have two and they are working fine. Don't use encryption.

On the second system, what version are you running and did it recently change? If it was working and now doesn't and the Z-Way version hasn't changed, then some other "change" has happened on your system. Did you recently apply any updates to the Raspberry Pi itself? Ultimately you need to...

Some of the early firmware releases for the Razberry 7 were buggy, bugs from Silicon Labs SDK that they resolved. So you might want to check your firmware level on the Razberry 7 board.

Since some like to hear the setups of others. I'm using CM4 modules and the carrier board is the Waveshare CM4-POE-UPS-BOX. This carrier board has built-in PoE so no HAT needed. It also has UPS functionality. So if I need to reboot the switch for code upgrades or a power failure, the system will sta...

I restored just the Z-Wave network and verified that the devices were shown in the controller. I tried the restore of the just the Z-Way systems (not the Z-Wave portion) and I ran into the same error. I told it to reset to factory defaults (not the controller) and all of the devices are there, just ...

So I have the zab and the zbk backup files. I'm trying to migrate from one system to another. I am running Z-Way as the Home Assistant add on. Before the restore, the Razberry 7 Pro was found. After the restore, it can no longer find the Razberry 7 Pro. I have verified that the controller is: /dev/t...

So the version for the Z-Wave.me Z-Way for Home Assistant Add-on is currently 4.1.0, are there plans to produce an updated release that corresponds to the latest Z-Way version?

Creating multiple threads and expecting others to remember your setup on a forum is a high expectation.

The 3.1.x train is old:

31.08.2020 v3.1.0

A lot has changed since then and you should be asking Fibaro about software updates.

Good luck with YOUR problem.