forum

... мне пожалуйста, сработает ли это всё, не будет ли конфликтов?? Устройства: 1. Контроллер Fibaro Home Center 2 2. Пульт-контроллер Aeotec Minimote 3. Датчик протечки и температуры FIBARO Flood Sensor 4. Датчик дыма Philio 5. Датчик утечки бытового газа Heiman 6. Датчик открытия двери/окна ...

... a number of ways to achieve your end result varying in complexity and difficulty. The easiest is to go out and buy something like an Aeotec Minimote for £50+ but you've bought a Zuno so probably want to put that to good use performing the same task. To emulate the minimote I believe would ...

I would like to use the Minimote as a scene controller, but can't even get it interviewed correctly.

Update: I just found out I have a similar problem with my minimote. This might actually help to debug it. My Minimote is configured so that is transmits scenes. Two of the buttons are used to control a Fibaro Wall Plug and the other controls a Fibaro ...

Hi, I have tried to configure it as "scene" or "central scene" type - and I will get buttons for every status - but can not use it in "logical rule" App (in "remote" is no device present). Did you do anything "special" to get the buttons? I've manag...

Hi there,

thanks, man. Thanks to your post, I tried again and through sheer persistance I succeeded.

Much obliged.

Regards, rws

Hello again, after reading this post http://forum.z-wave.me/viewtopic.php?f=3423&t=23445&p=62711&hilit=minimote#p62711 I tried again. Got a new minimote, upgraded the firmware and included the minimote into my network. Everything looked as before, grey, useless device. ...

... remote accepted the command(s) but didn't engage. May have been because I didn't associate the remote to device thinking back?? * To wake up V1 minimote: Hold the join button for 3 seconds (blue LED solid) until the red flashes quickly and both LEDs shut off. It's quirky and the button sequence ...

... the interview to fail before it was completed. Very basic, 4 command classes. When I attempt to pick the device description "Aeon Labs Minimote US", I get a error Error handling data /ZWave.zway/Run/devices[17].LoadXMLFile("223-0086-0001-0003-00-02-30-00-00.xml") . I ...

DSA03202v1 - tried to add it two times. Both times it created a ghost device ( 14, now 15 ). The configuration interview page after inclusion is blank. There are no elements or references created in the expert or automation GUIs. Running version v2.2.2-test-new-webserver. Has anyone gotten these bug...