official forum

I'm curios, would the if the rule work for you?

Seriously considering going back to Domoticz again. So you've been running Domoticz before? Why did you switch - just curious? Could you just write down some pros and cons - comparing those two? A bit off topic, but would be nice to hear about your practical experience :geek: 7es I'm interested as ...

I have never had an interview work. I always have to wait for it to fail the go back and run each interview step manually, see if that helps.

I have a Honeywell thermostat and I was having same problem device reporting Fahrenheit values but showing units as Celsius after updating config.xml file for fahrenheit. I forced interview of the thermostat in the expert UI and now the device reads correct value and units in Fahrenheit. Hopefully ...

I fully endorse this ability

You will eventually get hit by this as I have a few times. Please chime in on it here https://github.com/Z-Wave-Me/home-automation/issues/275 and here viewtopic.php?f=3422&t=22595

Both places, I feel they think I'm being pedantic

viewtopic.php?f=3419&t=22569&p=59997#p59997

I have a honeywell as well

config/Defaults.xml Search for Fahrenheit. Be sure to interview again or the cached value continues on the widget You will eventually get hit by this as I have a few times. Please chime in on it here https://github.com/Z-Wave-Me/home-automation/issues/275 and here http://forum.z-wave.me/viewtopic.ph...

I registered just so say the same - I so give up. Bought the razberry board today, played around with z-way for 3 hours now maybe. Devices are clearly picked up by the controller (z-way-server.log tells), but when adding devices, step2 inclusion just won't proceed. But Fibar group elements appear, ...

https://github.com/Z-Wave-Me/home-automation/issues/275

Honestly I just wish the state of switches in ui were in sync with the actual state of the switches