Search found 72 matches

by ridewithstyle
26 Dec 2016 18:53
Forum: Discussions in English
Topic: Remote Access limitations, Carrier NAT
Replies: 2
Views: 1581

Remote Access limitations, Carrier NAT

Hello there, Are there any limitations regarding the IP the zway server must have? I want to set up a second razberry system which is connected to the internet via surfstick/router of an ISP. So the router does not have a public IPv4, but instead some IP in changing private ranges. Would the remote ...
by ridewithstyle
18 Dec 2016 13:51
Forum: Discussions in English
Topic: Daylight32 & IF->THEN problems
Replies: 10
Views: 6581

Re: Daylight32 & IF->THEN problems

Hi there,

unfortunately, no I haven't. As this is my outdoor Shade-Control and I won't need it until next Spring, I am hoping that the next release will fix this problem in the meantime. Lazy approach, I know.

Regards,
rws
by ridewithstyle
02 Dec 2016 23:56
Forum: Discussions in English
Topic: Use of Vision ZD2102EU window sensor with IFTHEN
Replies: 4
Views: 3067

Re: Use of Vision ZD2102EU window sensor with IFTHEN

Hi there,

Just asking to clarify: Did it start working or stop working on your setup?

My observation is that switches, that are presumed to be on do not get triggered with the on-command. Same goes for off and switch-off commands.

Regards, rws
by ridewithstyle
24 Nov 2016 16:10
Forum: Discussions in English
Topic: Very advanced virtual Thermostat
Replies: 8
Views: 4739

Re: Very advanced virtual Thermostat

very true, the controlled system is very slow.

I plan to manipulate the target temperature of the thermostat using a delta-sigma principle between measured temps and room-target temps. The possibility of oscillation should be minimal if I use a hysteresis and various corrective measures :-)
by ridewithstyle
24 Nov 2016 14:31
Forum: Discussions in English
Topic: Very advanced virtual Thermostat
Replies: 8
Views: 4739

Re: Very advanced virtual Thermostat

My idea is to use the updated average temperature provided by the mathematica module . When either the average temperature or the target temperature get changed it will trigger the re-evaluation of the calculation. As i'm quite busy right now, I won't have the time to tackle this right away. Current...
by ridewithstyle
21 Nov 2016 14:40
Forum: Discussions in English
Topic: Very advanced virtual Thermostat
Replies: 8
Views: 4739

Re: Very advanced virtual Thermostat

thanks for the idea, I'll have to read up on my javascript skills prior to doing that, but it seems doable. I think this should be worth the effort, once I crack this problem, it'll open up further ideas. :-) Is there any codesample you know of where I can get into the proper syntax? thanks and best...
by ridewithstyle
20 Nov 2016 23:14
Forum: Discussions in English
Topic: Daylight32 & IF->THEN problems
Replies: 10
Views: 6581

Re: Daylight32 & IF->THEN problems

Update: I just found out I have a similar problem with my minimote. This might actually help to debug it. My Minimote is configured so that is transmits scenes. Two of the buttons are used to control a Fibaro Wall Plug and the other controls a Fibaro Roller Shutter 2. Two minimote scene buttons are ...
by ridewithstyle
15 Nov 2016 19:00
Forum: Discussions in English
Topic: Daylight32 & IF->THEN problems
Replies: 10
Views: 6581

Re: Daylight32 & IF->THEN problems

Hello, yes, the switched off was actually sent but nothing was triggered by it. (It worked for months with 2.2.2 and only with 2.2.4 the problems appeared) clarification: I only need the "daylight on" to trigger something, "daylight off" is not needed, hence it doesn't trigger anything. Still, I can...
by ridewithstyle
15 Nov 2016 15:37
Forum: Discussions in English
Topic: Very advanced virtual Thermostat
Replies: 8
Views: 4739

Very advanced virtual Thermostat

Hi there, I am looking for a solution to compensate a temperature gradient in the room using a default devolo/danfoss setpoint thermostat. Imagine a room where the heating radiator is on the inner warm side of the house and setting it to a temperature of e.g. 21°C will result in significantly lower ...
by ridewithstyle
15 Nov 2016 12:26
Forum: Discussions in English
Topic: Daylight32 & IF->THEN problems
Replies: 10
Views: 6581

Re: Daylight32 & IF->THEN problems

Hi there, first of all, thanks for the reply. I use the IF-THEN App for mapping scenes to switches and those all work fine. Only mapping Daylight32 to a scene somehow fails. Maybe that helps in diagnosing. To follow your advice, I just set up a logical rule as replacement, it'll take a 24h cycle to ...