forum

Hi, this topic is sooooo old :) In meantime the backup/restore is working. If you have old RaZberry - use latest version (rc17 or rc15) - then restore of your file will work. If you have new Gen 5 Razberry / UZB - make an update of bootloader and firmware first ( ... /expert/#/uzb ) We have it teste...

changes of dataholders withou RECEIVED are possible only via API Yes, tof course - this is my understanding too. That's why do not understand what happen here with this device. Attaced the full log after I have resetted the Razberry - to build a fresh network. I had this issue already before (see a...

no, I haven't filtered.

I already think that the Z-Wave chip have any problem.
Yesterday there was a big "nothing" ... today in the morning the thermostat began to send again....

Michael

Question:

Dimmer can not be used in Z-Way at all (because of this firmware bug) - or there are any limitations?

Thanks
Michael

today again.... strange issue. Configuration: Z-Way rc17 / Razberry + Eurotronic, nothing else. Was reporting fine all the time, then (full z-way log): No values more between 10:10 and 11:01, and after 11:16 .... [2015-11-30 10:00:00.380] [I] [core] --- ZWayVDev_zway_2-0-49-1 performCommand processi...

pz1 wrote:May I assume the wheel setting can be overruled by the next Z-Wave temperature setting?

Yes, written in manual that it is working, and just tested again, value will be overwritten if you change the value in Z-Way.

Michael

Hi, seems to be an interesting "meter" ;) written is "virtual power meter" In fact - there will be added the *predefined* consumption - given by a parameter: Paramter No. 20 Size 2 Default 0 Name Energy consumption Description: Specify the consumption of the load in watts, for th...

Hi, yes, we have tested. Mixed "feelings" ... Seems not to be very stable - one of them canceled reporting after some hours - wthout any Z-Wave message. deep deep sleep..... Must be woken up using micro switch. SetPoint can be set - but manual setpoint setting at device will not be reporte...

I have tested the NodOn switch in detail the switch now with Z-Way rc15. About the “power lost” problem: Configuration 1: After include set the parameter 2 to “1” – so that alarm will be reported. (maybe good idea to set it by default to “1” ? ) If power will be lost – device is reporting about this...

thanks for explainig

Sounds like perfect solution.
NodOn have special events for "power back" and "power loss" (buffered), so I will recheck it, maybe config for device is not right by default setting.

Will add result later.

Thank again.
Michael