forum

Thanks,
When do you believe there will be a documentation to explain how to move here?

It would be very useful for non-expert like me.
Saluti
Floriano

SolarFlor wrote:Hi PoltoS are the following two commands I should give on my Rasp to use the new RaZ-OR module?

I'm sure PoltoS is very busy. Anybody else that could help me on this.
Many Thanks

Hi PoltoS are the following two commands I should give on my Rasp to use the new RaZ-OR module?

PoltoS wrote:

Code: Select all

rm -Rf automation
git clone https://github.com/Z-Wave-Me/home-automation.git automation

You are also referring to a short manual but I cannot find it
Thanks for your support.

About option1, how I can use the new RaZ-OR module which comes with RaZberry 1.5-rc3?

As option3, may I load Z-Way 1.4.1 and follow your guide?

Hi Pieter, I have tried to use your instructions to configure Razberry automation engine but when I opened the config.json file I wasn't able to find the following section "CustomUserCode": { "module": "CustomUserCode", "config": { "customCodeFiles":...

Need your help again. The RaZberry is just arrived and I have configured it. I opened the Expert UI (I cannot find the demo UI) and I tried to conned a device (the Fibaro Wall Plug). Everything seems ok but it wasn't able to complete the interview even if I have forced it many times. What I should d...

pz1 wrote:See the official openremote installation page for raspberry:

Hi Pieter,
I have seen it (not aware that was from you) but I feeled warried reading your advice at the beginning of the page. Are the instructions you reported still valid?

Ciao

Sorry, another question. Are you suggesting to use Soft-float or Hard-float OS in my Rasp+RaZ? See the official openremote installation page for raspberry: I have already read there and both solution are available for OpenRemote, but I'm not sure if RaZberry can work on both as well. I was thinking...

Sorry, another question. Are you suggesting to use Soft-float or Hard-float OS in my Rasp+RaZ?

Many thanks for your advice. In fact this was my second question. I have already working a couple of codes on my Rasp (to measure production and consumption) so I wonder if the system could support a third program like OpenRemote. By the way are you reccomanding openremote for the Rasp or some other...