fibaro roller shutter 2
Posted: 11 Feb 2016 11:35
I am still in the planning phase of my setup and I have a question regarding the fibaro roller shutter.
My shutters at the moment have toggle switches. If i use the fibaro module, how will those behave?
I know they are supposed to work OK as i read that in the fibaro manual, but my question is specific:
If i open the rollers manually using the wall switch, the rollers will go all the way up, reach the mechanical limit of the motor and stop... my toggle switch will still be left on the up position.
If i then try to close the rollers using z-wave, will that work with the manual switch left in the UP position?
And if that works OK and i decide to open the rollers again with the switch, do i have to toggle the switch to middle position then back to UP again?
hope i make sense.. thank you
My shutters at the moment have toggle switches. If i use the fibaro module, how will those behave?
I know they are supposed to work OK as i read that in the fibaro manual, but my question is specific:
If i open the rollers manually using the wall switch, the rollers will go all the way up, reach the mechanical limit of the motor and stop... my toggle switch will still be left on the up position.
If i then try to close the rollers using z-wave, will that work with the manual switch left in the UP position?
And if that works OK and i decide to open the rollers again with the switch, do i have to toggle the switch to middle position then back to UP again?
hope i make sense.. thank you