Changing the country frequency

[vijayg78]

Hi,
I bought a Razberry Z wave daughter board from online (India) and they issues the EU frequency (2 years back approx). Its a 5th gen board. Now I see there is a specific frequency allocated for IN.

I also noticed that now the Country can be changed via the admin UI . I want to confirm that the country can be changed via UI. Is that possible or allowed? If i do that will I be able to use the IN specific devices with this board?

When i try to change the country, nothing happens, it just stays in the same page and i see the current frequency as "Unknown". Please let me know what step i am missing.

Really appreciate the support,
Best Regards,
Vijay

Hardware
Vendor: RaZberry by Z-Wave.Me
Vendors Product ID: 1024 / 1
Z-Wave Chip: ZW0500

Software Information
Version number: v2.2.5
Compile-ID: d58b7617c4f553beca4c6f41705b48fa5a4cf56c
Compile-Date: 2016-11-15 11:42:15 +0300

Firmware
Library Type: Static Controller
SDK Version: 6.51.03
Serial API Version: 05.00

[Z-Wave Support]

Hello,


please Update your Bootloader about Expert UI (First Bootloader, then Firmeware).

Best regards
Z-Wave Support

[vijayg78]

Hi,
Sorry to ask this, how to update Bootloader? Will just "wget -q -O - razberry.z-wave.me/install | sudo bash" update boot loader also? If that is the case i already did that. But Firmwire update is not going through.

Regards, Vijay

[vijayg78]

In the Expert UI i do not get an option to update the bootloader. The firmwire update is not going through from this page.

[Z-Wave Support]

Hello,

you can update your Bootloader in http://IP:8083/expert/#/network/controller.

good luck

regards

[vijayg78]

It did not help, for this URL i am getting a message "Could not retrieve data from remote server.". What might be the issue?

Regards, Vijay

[vijayg78]

Finally solved it via below step.

Downgraded to 2.2.2, did a fresh install to a new SD card. Used the browser in incognito mode (Very Important), i was able to see the options. Did upgrade of bootloader and firmwire. Then did reboot everything was ok.

Did a shutdown and swap of SD card, back to normal.

Thanks for the help,
Regards, Vijay