Z-Wave Sensors + Actuators
Posted: 17 May 2018 12:59
Hi there,
I have setup a very simple Gateway using a RaspberryPi running Hassio and have a Aeoteck Z-Stick Gen5.
I am now looking to implement my own devices on the Z-Wave network.
I would like to create a device that is measuring device with a piezo sounder. When a measured parameter exceeds a predetermined level, it will beep an alarm. It will send out a message that will cause remote devices to beep an alarm.
I have read something that states that a Z-Wave device can be either a Sensor or an Actuator - I think my requirements mean I need my device to be both Actuator and Sensor - Is this possible?
Thank in advance.
Andy
I have setup a very simple Gateway using a RaspberryPi running Hassio and have a Aeoteck Z-Stick Gen5.
I am now looking to implement my own devices on the Z-Wave network.
I would like to create a device that is measuring device with a piezo sounder. When a measured parameter exceeds a predetermined level, it will beep an alarm. It will send out a message that will cause remote devices to beep an alarm.
I have read something that states that a Z-Wave device can be either a Sensor or an Actuator - I think my requirements mean I need my device to be both Actuator and Sensor - Is this possible?
Thank in advance.
Andy