UZB Stability
Posted: 24 Jun 2018 10:42
Hi guys
I've been using an Aeotec Z-Stick with my HomeSeer setup for a little while now with no issues.
However the Z-Wave.ME UZB attracted my interest given it is actively developed with updates to the latest standards.
So I now have one, wiped my entire setup, and started setting up from scratch. I quickly ran into two issues:
1. Live status updates did not work. Some readings such as power levels came through on the secondary associations, but via the lifeline nothing worked. e.g. I turn on a light and HomeSeer was not showing it. After much troubleshooting I discovered lifeline association would only work for 5 seconds - if I removed it and readied then turning on or off a light would update instantly, no matter how many times I did it, within that first 5 seconds.. then nothing again.
2. Unpairing devices resulted in a system crash.
So I started over again with the Z-Stick and all is well again.
Is there a problem with the HomeSeer implementation of the Z-Wave.ME UZB support, or is there some bugs in the Z-Wave.ME UZB firmware? On version 5.27
I've been using an Aeotec Z-Stick with my HomeSeer setup for a little while now with no issues.
However the Z-Wave.ME UZB attracted my interest given it is actively developed with updates to the latest standards.
So I now have one, wiped my entire setup, and started setting up from scratch. I quickly ran into two issues:
1. Live status updates did not work. Some readings such as power levels came through on the secondary associations, but via the lifeline nothing worked. e.g. I turn on a light and HomeSeer was not showing it. After much troubleshooting I discovered lifeline association would only work for 5 seconds - if I removed it and readied then turning on or off a light would update instantly, no matter how many times I did it, within that first 5 seconds.. then nothing again.
2. Unpairing devices resulted in a system crash.
So I started over again with the Z-Stick and all is well again.
Is there a problem with the HomeSeer implementation of the Z-Wave.ME UZB support, or is there some bugs in the Z-Wave.ME UZB firmware? On version 5.27