I am a bit confused about you should look at programming rules in Z-way.
I started setting up a rule that says that when I turn lamp A on at the wall switch, in which there is a Fibaro Single Switch 2 (FGS-213) then the blinds should also open. Should be simple I thought.
But, when I turn the lamp ON, I get no event in my event log, and the blind does not raise.
Is this normal behavior? Is there something I need to do to get rules to be triggered by a wall switch?
Discussions about Z-Way software and Z-Wave technology in general
1 post • Page 1 of 1