Page 1 of 1

Should not switch ON or OFF generate an event?

Posted: 19 Jul 2018 21:11
by FredrikKarlsson

I am a bit confused about you should look at programming rules in Z-way.
I started setting up a rule that says that when I turn lamp A on at the wall switch, in which there is a Fibaro Single Switch 2 (FGS-213) then the blinds should also open. Should be simple I thought.

But, when I turn the lamp ON, I get no event in my event log, and the blind does not raise.

Is this normal behavior? Is there something I need to do to get rules to be triggered by a wall switch?