Z-Way & UZB Smart Start

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
pwalton321
Posts: 1
Joined: 16 Aug 2019 17:30

Z-Way & UZB Smart Start

Post by pwalton321 » 16 Aug 2019 17:35

I am currently running Z-wav v3.0.0 on a Raspberry Pi, along with a UZB stick running version 5.34. I am trying to add a node via Smart Start, however do not see the option in either Expert UI or Add a device through the normal UI. Under controller data I can see the following info at the very end;

smartStart: None (14:59)
requestFrom: None (14:59)
dskProvisioningList: None (14:59)
includingDSK: (15:02)

I am wondering if there is a way to enable smart start? All mentions of the current firmware for UZB and Z-Way v3.0.0 do seem to state that Smart Start and S2 is supported.

Thanks

User avatar
PoltoS
Posts: 4954
Joined: 26 Jan 2011 19:36

Re: Z-Way & UZB Smart Start

Post by PoltoS » 19 Aug 2019 22:07

Go Smart Home/Devices/Z-Wave/Manage/Smart Start

Post Reply