I purchased a Linear GD00Z-4 garage door opener last year and it worked perfectly without a hitch.
I am using a Samsung SmartThings v3 hub. I am controlling using the app and Alexa.
Then all of a sudden, it only started understanding “close” commands and the sensor wasn’t sensing the correct status of the door. I replaced the batteries, reset the controller, removed & re-added the device. I even bought an entire new device.
The new device is now having the same issues as the old one.
When I run a “Z-Wave Network Repair”, I usually get these errors:
“Network repair for Garage Door [13]. Could not assign new route.” “Network repair for Garage Door [13]. Could not delete old routes.” “Network repair for Garage Door [13]. Could not update neighbors.”
How can I fix these? Thanks!
How to fix Z-Wave errors with Linear GD00Z-4 Garage Door opener?
-
- Posts: 1
- Joined: 30 Aug 2019 08:50
-
- Posts: 1
- Joined: 09 Jun 2020 10:25
- Location: USA
Re: How to fix Z-Wave errors with Linear GD00Z-4 Garage Door opener?
hi,
you can try to reboot the system, by doing that it will help in restoring all the command as new.
thanks
you can try to reboot the system, by doing that it will help in restoring all the command as new.
thanks