"missing" Battery Devices after reinstallation
Posted: 12 Oct 2019 13:55
Hi together,
last night my SD Card in my Raspi 2 died.
After reinstallation (and upgrade to a Pi3 and v3.0.0) the system can not communicate with my battery powered devices (Fibaro smoke sensor, Aeotec wallmote and nodon Wallswitch).
I had the chance to use an older backup, and all devices were found in general, but all with generic names like "BatteryDevice _10"
Even the mains-operated devices had the same problem, but with a "force Interview" everything went fine. Even a battery operated Danfoss Radiator Valve Thermostat went fine.
But no chance with the other battery devices. Maybe a complete exclusion/inclusion cycle will help, but this is only the last option, because of all scenes, and groups needs to be adjusted afterwards.
Any ideas?
best regards
Jarry
last night my SD Card in my Raspi 2 died.
After reinstallation (and upgrade to a Pi3 and v3.0.0) the system can not communicate with my battery powered devices (Fibaro smoke sensor, Aeotec wallmote and nodon Wallswitch).
I had the chance to use an older backup, and all devices were found in general, but all with generic names like "BatteryDevice _10"
Even the mains-operated devices had the same problem, but with a "force Interview" everything went fine. Even a battery operated Danfoss Radiator Valve Thermostat went fine.
But no chance with the other battery devices. Maybe a complete exclusion/inclusion cycle will help, but this is only the last option, because of all scenes, and groups needs to be adjusted afterwards.
Any ideas?
best regards
Jarry