Cannot pair anything on new setup

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
latitude
Posts: 2
Joined: 12 Aug 2017 12:07

Cannot pair anything on new setup

Post by latitude » 12 Aug 2017 12:14

Hi there,
I am new to all this and have just purchased a raspberry pi and razberry conrtoller board. I installed the standard image from http://razberry.z-wave.me (done it several times and flashed several cards - even tried a different raspberry pi). First I purchased some qubino relays - they just wont pair - next i bought some Vision sensors and they too wont pair. It just says inclusion takes a long time to start and does nothing. I tried to contact intuitech (the supplier) in case there is a problem with the board itself but have not gotten a response. Does anyone have any insight that might help me?
Thanks in advance.

User avatar
PoltoS
Posts: 3584
Joined: 26 Jan 2011 19:36

Re: Cannot pair anything on new setup

Post by PoltoS » 13 Aug 2017 11:27

Make sure the frequency is same (change frequnecy in the Expert UI -> Netwrok -> Control).
Try to exclude first.
Make sure to correctly initiate learn mode on the device itself.
Move the device closer.

latitude
Posts: 2
Joined: 12 Aug 2017 12:07

Re: Cannot pair anything on new setup

Post by latitude » 13 Aug 2017 23:42

Hi and thanks for the reply. As it happens I decided to order another unit which has installed and paired to several vendors products seamlessly on the same pi/zwave install. Strange but to me that definitely says there is a fault on the original z-wave board.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests