How to associate switches to EZmotion using RaZberry?

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
McD
Posts: 17
Joined: 28 Mar 2013 14:15

How to associate switches to EZmotion using RaZberry?

Post by McD » 30 Mar 2013 02:06

In my network there is an EZmotion. The manual (http://www.expresscontrols.com/pdf/EZMo ... Manual.pdf) says

"Assigning associations to EZMotion will depend on the Primary Controller capabilities or the home-control application. Refer to the documentation for these devices on how to assign associations to EZMotion."

How do I set this association up in RaZberry?
Are there pages of documentation or config switches for this, which I have not seen?

User avatar
PoltoS
Posts: 4536
Joined: 26 Jan 2011 19:36

Please read the manual

Post by PoltoS » 30 Mar 2013 02:06

Please read the manual (section 7.4.3). You need to use drag&drop on the tab Device Configuration

Post Reply