How to associate switches to EZmotion using RaZberry?
Posted: 30 Mar 2013 02:06
In my network there is an EZmotion. The manual (http://www.expresscontrols.com/pdf/EZMo ... Manual.pdf) says
"Assigning associations to EZMotion will depend on the Primary Controller capabilities or the home-control application. Refer to the documentation for these devices on how to assign associations to EZMotion."
How do I set this association up in RaZberry?
Are there pages of documentation or config switches for this, which I have not seen?
"Assigning associations to EZMotion will depend on the Primary Controller capabilities or the home-control application. Refer to the documentation for these devices on how to assign associations to EZMotion."
How do I set this association up in RaZberry?
Are there pages of documentation or config switches for this, which I have not seen?