Fibaro Door/Window Sensor

Isaksson · Post by **Isaksson** » 14 Apr 2013 20:35

Hello.
I have just included a Door/Window sensor from Fibaro and i have no problem reading the state if its open or closed but i have also added a DS18B20 and my question is if it is possible to view the temperatur from the sensor in the included webgui?
What is the right syntax to grab that value with API?
Thanks

krambriw · Post by **krambriw** » 14 Apr 2013 20:35

Isaksson, see below for my device '6' and tempsensor on instance '3'

BestR Walter

http://192.168.10.248:8083/ZWaveAPI/Run ... .val.value

Isaksson · Post by **Isaksson** » 14 Apr 2013 20:35

Thanks.
To bad it did not work for me.
Uncaught TypeError: Cannot read property 'data' of undefined

krambriw · Post by **krambriw** » 14 Apr 2013 20:35

Isaksson · Post by **Isaksson** » 14 Apr 2013 20:35

I had to exclude / include the device after adding the temp sensor. Now I could see both state and temp in the webgui.

_835_ · Post by **_835_** » 14 Apr 2013 20:35

@Isaksson,
which z-way version you used ?
i do not have success including my fibaro fgk-101, (i got 2) with z-way 1.3.1 and 1.4.1-rc1.
while my aeon 4-1 multi sensor goes fine...

Isaksson · Post by **Isaksson** » 14 Apr 2013 20:35

I had to roll back to version 1.3.1 to get the sensors to work.
Use the "tamper" button on the back to include it, push as fast as you can.

forum