Help: HSM100-S3 Multi-Sensor always shows "triggered" state

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
aibojian
Posts: 5
Joined: 20 Jul 2013 08:25

Help: HSM100-S3 Multi-Sensor always shows "triggered" state

Post by aibojian » 04 Aug 2013 07:22

Hi,

I've 2 HSM100-S3 Multi-Sensor devices, both temperature and luminescence are working as expected, but the motion detector is not working. In Z-Way controller demo site, both devices always showed "triggered" as they have detected movements, and never go into idle state. I turned Sensitivity down to 150, 100, 50 and 0, all showed the state as "triggered". Thanks in advance.

aibojian
Posts: 5
Joined: 20 Jul 2013 08:25

no longer an issue

Post by aibojian » 04 Aug 2013 07:22

I had to set the "On time : Minutes" to 1 to the the value change, the default value was set at 20 mins. :)

breywatwilles
Posts: 1
Joined: 10 Oct 2013 15:48

Check out the manual for

Post by breywatwilles » 04 Aug 2013 07:22

Check out the manual for proper settings of motion sensor security lighting, sometimes it happens we often used to do all the settings and we feel that what ever we had done is correct but we left some points of connection,, just check it out!!

Post Reply