Everspring ST 814 don't work on my fresh Install 1.4

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
Allen912
Posts: 9
Joined: 02 Oct 2013 20:25

Everspring ST 814 don't work on my fresh Install 1.4

Post by Allen912 » 02 Oct 2013 22:15

Hi,

I just set up my new Razberry installation. Everything goes fine excepted the SensorMultilevel Everspring ST814. It doesn't work at all. After a few minutes of trying "interviewing", it displays : "Interview failed after several attempts".

I got two others everspring switch module AN157 which work fine...

Here are the details of the failure module :

Device description
Node Id: 6
Name: Device 6
Zone: Not placed in a zone
Custom device type:
Brand: Everspring
Device type: Routing Multilevel Sensor
Product: ST814
Description: Temperature/Humidity Sensor
To (re-)include: Tripple press C/F button
To wake up: Stays awake for 10 min. after inclusion, tripple click on C/F
Documents:
Interview stage: Interview failed after several attempts
+ +++ ø++ø++ ø ø
Device state: Device is currently sleeping
Number of packets to be sent: Per-device job counter is disabled
Application version: 1.6
SDK version: 5.02 pl2
Associations
Battery Status and Sensor Report (Maximum allowed nodes: 1, updated 20:11)
RaZberry
Sensor Triggered (Maximum allowed nodes: 3, updated 20:11)
RaZberry
Configurations
1. Basic Level Set : Disable Use value
Updated: 20:13
Default value: 99
Set basic set value to be on or off
2. Temperature Trigger ON value : Trigger On on Trigger On on Disable
Updated: 20:13
Default value: 99
Temperature level when a ON command is sent out
3. Temperature Trigger OFF value : Trigger Off on Trigger Off on Disable
Updated: 20:13
Default value: 99
Trigger Temperature level when a OFF command is sent out
4. Humidity Trigger ON value : Trigger On on Disable
Updated: 20:13
Default value: 99
Humidity level when a ON command is sent out
5. Humidity Trigger OFF value : Tigger Off on Disable
Updated: 20:13
Default value: 99
Humidity level when a OFF command is sent out
6. Auto Report Time : Disable Auto report periodically
Updated: 20:13
Default value: 0
Sets the time interval when a sensor report is sent
7. Auto Report Temperature : Disabled Auto report on temp. change
Updated: 20:13
Default value: 0
Sets the temperature change causing a sensor report
8. Auto Report Humidity : Disable Auto report on humidity change
Updated: 20:13
Default value: 0
Sets the humidity change causing a sensor report
Wakeup notifications
Wakeup time, seconds(300)
to Node
Updated: 20:11
Actions with configurations
Configurations are applied only after you send them to the device

The device is battery powered. New configurations would be applied after manual or next scheduled wakeup at 21:14
Advanced actions


Thank you for your help,

Allen

Post Reply