Hi,
I read thru all the guides and went set by set doing the install of the zwave board onto my pi. I have several devices that the software UI should be seeing but I am not getting anything. It looks like it sees my raz but nothing else.[img]Screen%20Shot%202014-05-01%20at%205.43.13%20PM[/img] I am just seeing this error on the network page."to configure controller behavior use home automation (not implemented yet).
Any ideas?
thanks,
anthony
newbie here
Re: newbie here
no screenshot attached. have you included devices?
Re: newbie here
I tried to but when i hit to include nothing includes. I know the devices work since they were hooked up to an older wave verizon controller.
Re: newbie here
You probably need to exclude them first (since they're associated with another home ID), and then include them.