Razpberry & Fibaro FGS221

[jfadel]

Hi

I am new to the z world .. I am trying to include a Fibaro FGS 221 to a Razberry, and it fails all the time, I tried pushing the button 3 times very fast, I updated the rasberry, I tried pushing the button far beyond 3 times .. I succeeded once to have it included by the raspberry, and I succeeded to switch on/off light on the first relay .. But as soon as I power cycled the raspberry, it is no longer recognized and it says "Device is dead" .. I succeded to exclude the device, but always failing to include again !!

I am using z-way default interface ..
Razpberry version v1.7.0
FGS 221 version is V2/1 10/04/2014
Raspberry version 3.12.20

Any ideas ?
Thanks a lot

[PoltoS]

What is the date on the RaZberry board?

[alboon]

just install fgs221
when problems just reset fgs221 and re-includ it :

just un plug power and press (old) B, plug power and in 3seconds unold B, it's reset (sorry for my english)

[jfadel]

PoltoS,

The date of my board is 15/04/2014

[pofs]

The date of my board is 15/04/2014

It is one of the boards with broken EEPROM.
Please contact your supplier for replacement.

[jfadel]

Can I have an official document or mail from wave.me about the faulty boards, because me reseller www.my-domotique.com is refusing to change the board without something official from wave.me or an email ..
What is the procedure to have this official doc

Thanks

[jfadel]

Thanks, I got a replacement board from the europe distributer but unfortunately with this new board, its worse, I am unable to include devices at all .. !! Is there something missing !! it is dated 16/06/2014

[darkyat]

Thanks, I got a replacement board from the europe distributer but unfortunately with this new board, its worse, I am unable to include devices at all .. !! Is there something missing !! it is dated 16/06/2014

Have you already tried to flash your SD once more with the newest image?
What do you see in the /var/log/z-way-server.log while trying to include a new device?

[kambis]

Hm..., just came in my mind while reading your post:
Did you excluded all your devices before? The new controller has a new network HomeID and you need to reset all devices before you can include them into the new network. A new controller has by nature a different ID than your old one.

[jfadel]

thanks all .. It is fixed, I had the device badly connected, that is why it was not included