Problem with Fibaro Motion Sensor...

[Hwoahwoa]

Hi,
Im new here, so i already thanks you for helping me

Platform :
Raspbery with the last Raspbian.
RaZberry with v1.7.1-rc1

My problem... I include my Fibaro Motion Sensor, everything is okay, i have the 2 sensors (Temp/Lux), but if the device go to the sleep state, The sensor will never be recognized by the controller... I try to exclude him... but nothing.
If i include them again, the sensor is added but with a new ID...

I think the id of the device are not save... it's possible ?! Somebody have encounter the same issue ?

Thxx

[pofs]

Check your RaZberry manufacture date. If it is middle of April, you'll need to replace it.

[Hwoahwoa]

Oh....

Indeed... 14 April.... what is the problem with this Razberry ?

[pofs]

There was a batch of RaZberries with broken EEPROM in April. Unfortunately, not all of them were revoked in time.
Please contact your reseller for replacement.

[sdh]

where exactly is the date printed?

[pofs]

where exactly is the date printed?

It is printed on the other side of the board, approximately under antenna.

[SolarFlor]

This morning my Fibato Motion Sensor (device 7) invented a new device called 'tank capacity' and the measure is 1 cube meter
What is it?
May I remove it?

[PoltoS]

We have seen this from time to time. Looks like corrupted packet (due to RF or problem in the device - first is more probably). Can you show us the log where it comes first time? (search for "cbm" line).

[SolarFlor]

could you remind me where the log file is?
thanks

[pz1]

/var/log/z-way-server.log