Device interview stage is not complete

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
ms31
Posts: 4
Joined: 22 Apr 2015 23:40

Device interview stage is not complete

Post by ms31 » 28 Apr 2015 09:42

Hi all,

I habe two battery powered sensor of Fibaro (Motion sensor and FGK-101 door / window). I could include and exclude the device pretty well, but the interview stage is not complete :oops: . I have reset the sensor manual, etc.!

Interview-Status

Door sensor - Device interview stage is not complete + ..+ +.++.....
Motion sensor - Device interview stage is not complete + ..+ +..++....+.


any ideas

Thanks
Maik

dolpheen
Posts: 119
Joined: 10 Feb 2015 00:38

Re: Device interview stage is not complete

Post by dolpheen » 28 Apr 2015 18:21

Have you tried to wake up sensors duiring inclusion? (I have same sensors with full interview passed)
Razberry B+ 2.0.1-rc25 on ZW500 + 15 devices / Razberry B 2.0.1-rc25 on ZW300 for test

pz1
Posts: 2053
Joined: 08 Apr 2012 13:44

Re: Device interview stage is not complete

Post by pz1 » 28 Apr 2015 20:10

dolpheen wrote:Have you tried to wake up sensors duiring inclusion?
Or during Force-Interterview

Post Reply