Sorry for double posting, I posted this in the general discussion, where it obviously does not belong.
to my problem:
I have the Razberry running - I can access all things via the expert interface. However it seems I can not login via the smart home interface.
As discussed in an earlier post, the Razberry ID is not shown, but I can access the interface either via the find.z-wave.me or via the direct IP.
In both cases, I end up with an interface that asks me to login, tells me at the same time, that the first login goes via admin - admin and then I am lost.
It seems I have changed the login to this interface in the past, but I can not get back to it. Does anybody know where to set the users via command line or via the expert interface?
Discussions about RaZberry - Z-Wave board for Raspberry computer
1 post • Page 1 of 1