Siegenia Sensoair configuration

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
lowilly
Posts: 5
Joined: 06 May 2015 11:32

Sensoair Siegenia

Post by lowilly »

Hello everyone!
Does anyone tested this CO2 sensor with the razberry?
SiegeniaAubi - Sensoair Z-Wave CO2-Sensor SIG_SENS_W

https://www.siegenia.com/it/00002/0004/ ... index.html
lowilly
Posts: 5
Joined: 06 May 2015 11:32

Siegenia Sensoair configuration

Post by lowilly »

Hi, I need some help to understand how to configure a Siegenia Sensoair
https://www.siegenia.com/en/products/ve ... soair.html

Here there is a part of the manual with commands class
Image
Image

I want to enable the Unsolicited multilevel report mode B
I think I have to set the configuration with a value of "143", but I don't know where I have to insert this value
Last time I tried I messed up something, and I had to reset to factory the sensor

Also, how can I set the interval (preset at 30s) to 2 minutes?

Image
This is the part configuration of this sensor, under the expert commands tab

Anyone can help me?
Post Reply