Fibaro Wall Plug - Interview never completes.

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
sja
Posts: 7
Joined: 30 Mar 2015 09:37

Fibaro Wall Plug - Interview never completes.

Post by sja » 28 Apr 2016 10:02

Hi!

It seems that there is a Problem with the Z-Way Z-Wave stack or the Fibaro Wall Plug (FGWPF-101). I've got version 2.2.2 installed and I tried to reset and re-include this device, but the interview step never gets finished. I waited for about 12h to complete, but the system stick at this state: (Screenshot) https://www.dropbox.com/s/64j2370ri7jmt ... 5.png?dl=0
The inclusion was between a third node, so no direct communication between razberry and the plug was possible.
All the other nodes (~10) are working fine.

Do you have any advice?

BR
Sebastian

sja
Posts: 7
Joined: 30 Mar 2015 09:37

Re: Fibaro Wall Plug - Interview never completes.

Post by sja » 28 Apr 2016 11:20

Ah, forget to mention:
If I move the plug next to the raspberry, the interview is finished very fast. And then the device is dead. Here a screenshot of the job queue, after I switched to the Configuration tab in expert UI and pressed "Update from device" because all values were red (out of sync): https://www.dropbox.com/s/g5pd2k5ue4f3t ... 1.png?dl=0

Is this device just crap?

One more screenshot with from the Interview tab with version numbers: https://www.dropbox.com/s/6jfqz7xgo11qm ... 9.png?dl=0

Post Reply