Configuration not stored to device

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
_Thomas_
Posts: 4
Joined: 08 Jul 2016 14:52

Configuration not stored to device

Post by _Thomas_ » 08 Jul 2016 22:33

Hi,

I have major difficulties to store configuration to devices like an "Aeotec Siren Gen 5 EU" for instance. The Z-Wave Expert interface constantly states:

Nº 1 - Siren Sound/Volume: Value was changed to Set the volume to 100 dB but not stored in device yet.

Device interview and type is set correctly. It is no battery device.

Image

Related: A battery device have to be woken up, but how to do this? I can not find something like this in the interface.

Z-Wave version:
Firmware version v2.2.2
UI version 1.4.0
Capabilities: Slm

bogr
Posts: 179
Joined: 16 Nov 2015 22:46

Re: Configuration not stored to device

Post by bogr » 08 Jul 2016 23:58

I've had the same problem with other devices. It usually works by setting the param to something else, and then set it back to the desired value. Probably a bug in the interface.

The device should have a button you can press, which then wakes it up. You can't do that from the UI.

_Thomas_
Posts: 4
Joined: 08 Jul 2016 14:52

Re: Configuration not stored to device

Post by _Thomas_ » 11 Jul 2016 12:13

I have the impression there is something broken in this specific device. I have contacted Aeotec for support in this case. Will keep informed here.

babelmonk
Posts: 3
Joined: 17 Dec 2016 14:40

Re: Configuration not stored to device

Post by babelmonk » 17 Dec 2016 14:44

_Thomas_ wrote:I have the impression there is something broken in this specific device. I have contacted Aeotec for support in this case. Will keep informed here.
I have exactly the same problem with this Siren. Any updates @_Thomas_?

Post Reply