razberry keeps requesting battery status on dead device

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
ibjr
Posts: 6
Joined: 05 May 2016 21:52

razberry keeps requesting battery status on dead device

Post by ibjr » 24 Oct 2017 13:09

I have a Danalock V3 in my network; at a certain moment it did not respond to lock/unlock command, due to empty batteries. After I requested the battery status of this device in Expert mode via Device->battery->update, Razberry keeps requesting this info forever, although the jobs fail of course. After sometime it is no longer possible to execute commands to other devices; they all fail. Rebooting Razberry resolves this until you do another request of the battery status of this (dead) device.

Post Reply