The FIBARO RGBW Controller has 2 operation modes, RGBW mode to control ed. LED strips and a input/output mode.
Default it's in RGBW mode. When I include this device to the network it's a RGBW device but I need it in input/output mode. Therefor I need to configure parameter 14 to 34952. I can do this in the configuration tab of this device. But the device mode is not changed. Not after power cycle or a re-interview. When I exclude and re-include the device, it's back into the default mode.
Does someone know how to do this?
Discussions about RaZberry - Z-Wave board for Raspberry computer
1 post • Page 1 of 1