Re: razberry v2 shield problem (dead?) after firmware update
Posted: 23 May 2019 12:21
Forgot i was still running on v.2.8.1. After i updated to v.2.3.8 the logs began updating again. Same error, logs show:
Attached new logs from var/log/z-way-server.log
Code: Select all
[2019-05-23 11:13:18.427] [D] [zway] Opened device: /dev/ttyAMA0
[2019-05-23 11:13:18.427] [D] [zway] Worker thread successfully created
[2019-05-23 11:13:18.427] [D] [zway] Worker thread entry point
[2019-05-23 11:13:18.427] [I] [zway] Adding job: Get controller info and supported function classes
[2019-05-23 11:13:18.437] [D] [zway] SENDING: ( 01 03 00 07 FB )
[2019-05-23 11:13:18.639] [I] [zway] Job 0x07 (Get controller info and supported function classes): No ACK received before timeout
[2019-05-23 11:13:18.639] [D] [zway] SENDING: ( 01 03 00 07 FB )
[2019-05-23 11:13:18.840] [I] [zway] Job 0x07 (Get controller info and supported function classes): No ACK received before timeout
[2019-05-23 11:13:18.840] [D] [zway] SENDING: ( 01 03 00 07 FB )
[2019-05-23 11:13:19.042] [I] [zway] Job 0x07 (Get controller info and supported function classes): No ACK received before timeout
[2019-05-23 11:13:19.042] [W] [zway] Job 0x07 (Get controller info and supported function classes) dropped: too many resends
[2019-05-23 11:13:19.042] [D] [zway] Job 0x07 (Get controller info and supported function classes): fail
[2019-05-23 11:13:19.042] [C] [zway] Get Serial API Capabilities returned zero.
[2019-05-23 11:13:19.042] [I] [zway] Removing job: Get controller info and supported function classes
[2019-05-23 11:13:19.052] [D] [zway] Worker thread exit point
[2019-05-23 11:13:19.052] [D] [zway] Worker thread successfully finished
[2019-05-23 11:13:19.063] [E] [zway] SaveData will not save data since it wasn't loaded. This is to prevent data loss.
[2019-05-23 11:13:19.083] [I] [core] Error: Bad data - communication failed
[2019-05-23 11:13:19.084] [I] [core] Tried 5 times without success. Stopping tries.
[2019-05-23 11:13:19.087] [I] [core] Notification: critical (z-wave): Cannot start Z-Wave binding: Error: Bad data - communication failed