I just bought a ZMEKRAZ2 EU

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
le_slash
Posts: 2
Joined: 30 Apr 2019 11:59

I just bought a ZMEKRAZ2 EU

Post by le_slash » 09 May 2019 14:24

I just bought a (RaZberry2 ZMEKRAZ2 EU) and when I try to change region to EU in Z-way advance I just have option KR or JP, all other is grayed out.

I have run the sh script (sh changezwf.sh /dev/ttyAMA0 EU) and juppii (Switch to European Frequency (848.4 ... 869 MHz)) BUT!!!
but but :( after a restart, RaZberry is back to JP or KR.

Do I need a firmware update to change or am I stuck with some KR / JP region

and what is up with this token circus to access FW update, I could use one :)

Thanks for reading my post, hope you have a solution 4 me :)

User avatar
PoltoS
Posts: 4951
Joined: 26 Jan 2011 19:36

Re: I just bought a ZMEKRAZ2 EU

Post by PoltoS » 09 May 2019 16:08

Z-Way is not changing the frequency itself. So may be you executed that command or pressed the button accidentelly.

Also be noted that KR and EU uses same filters, so the range will be very small.

le_slash
Posts: 2
Joined: 30 Apr 2019 11:59

Re: I just bought a ZMEKRAZ2 EU

Post by le_slash » 09 May 2019 20:58

Hey PoltuS

I need some help, is there a guide on how to change the region from KR to EU

and what does the physic bottom do on the RaZberry,

Thanks

User avatar
PoltoS
Posts: 4951
Joined: 26 Jan 2011 19:36

Re: I just bought a ZMEKRAZ2 EU

Post by PoltoS » 10 May 2019 12:20

The button goes to RPi pins. You can catch it using standard pins system in Raspbian. Nothing is done on the Z-Wave side.

As for frequency change, do IP:8083/JS/Run/zway.ZMEFreqChange(8)

Post Reply