Danalock v3 failed to connect

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
giwwi
Posts: 1
Joined: 09 Sep 2019 22:50

Danalock v3 failed to connect

Post by giwwi » 12 Sep 2019 13:23

Good day,

After a year of almost excellent work I decided to update my Razberry and Danalock to last firmwares. Right now I have Z-way server 3.0.0 and Danalock v3 with 0.11.0 firmware. Each time when I try to connect my lock to razberry it fails (secure connection - fails on 38%, unsecure - 25%).

Hope, someone can help me)
Logs attached.
Attachments
z-way-server.log.zip
(100.44 KiB) Downloaded 2 times

nemo
Posts: 2
Joined: 12 Sep 2019 18:53

Re: Danalock v3 failed to connect

Post by nemo » 12 Sep 2019 19:28

@giwwi seems to have pretty much the same issue that I have, with pretty much the same setup (Z-way-server 3.0.0, Danalock v3 with FW 0.11).
The difference is that I do not have HomeAssistant installed on my RaZberry Pi (only Raspbian Stretch). Several Danalocks worked with the previous version of z-way-server without an issue.
Could it be that the new z-way release 3.0.0 created some incompatibility with Danalock?
I also attach my z-way-server.log file to see the similarities.
Hope that someone can help us.
Attachments
z-way-server.log.zip
(8 KiB) Downloaded 2 times

brun368
Posts: 11
Joined: 12 Sep 2015 01:49

Re: Danalock v3 failed to connect

Post by brun368 » 13 Sep 2019 09:37

Some problem here with Firmware 0.11.0. (Interview ends at 38%)
But with an older Version of the Firmware (sorry don't know the exact rev) the inclusion and interview was successful (with Z-Way 3.0.0). Therefore I think it is a problem with the Firmware.
I already contacted Danalock but i didn't get an answer so far. Please could you also contact Danalock and ask for a solution?

Post Reply