No Humidity from Popp 123559 or POP_004308 Smoke Detector

[rabing]

Hi,

the Popp 123559 or POP_004308 Smoke Detector hast a temperature and humidity sensor.
However, during interview only the temperature sensor shows up:

http://a.b.c.d:8083/ZWaveAPI/Run/device ... .val.value

The "Device Configuration" page in the expert UI has configuration settings for humidity. But
how can I get the humidity value?

[rabing]

Got the answer from Popp:
The current hardware version has problems with the humidity sensor calibration.
Therefore the humidity sensor is currently disabled and will be replaced by other
hardware in a few months...