SSR303

Discussions about existing Z-Wave device and their usage with Z-Way/Z-Cloud/Z-Box
Post Reply
Vmartinvega
Posts: 10
Joined: 30 May 2015 16:58

SSR303

Post by Vmartinvega »

Hi

This module works ok in the z-wave network but when I manually modify the actuator state (I push ON button) the controller doesn't reflect this value and it continues as OFF value, so if someone presses manually some button there is not way to be notified. I don't know if this behavior is a known issue, it is a bug in the device firmware (SSR303) or a bug in the controller (Razberry). Anyone can help here?

Regards
Post Reply