Page 1 of 1

Fibaro Door/Window Sensor - Reset tamper

Posted: 30 Mar 2017 17:57
by vegardb123
Hi!

I've got a Window/Door Sensor from Fibaro, and the tamper alarm is constantly in an "ON" state. The alarm is activatet by pushing the button on the back of the sensor.
This isn't a problem when using for example a Fibaro Motion Sensor, because that sensor resets the tamper alarm after a set time.
How can I reset the tamper alarm in the Door/Window sensor without having to remove it from the system and adding it again every time? Is there any script commands I can use?

Thanks!

- Vegard

Re: Fibaro Door/Window Sensor - Reset tamper

Posted: 20 Jan 2022 00:53
by zuperman
Hello Vegard, I am facing the same problem.
Did you find a solution?
Thanks
Erik

Re: Fibaro Door/Window Sensor - Reset tamper

Posted: 21 Jan 2022 02:20
by PoltoS
Some devices do not reset back the tamper after they are back to normal position.

For such devices, we have a "postfix" with emulateOff. Please check the following example:
https://github.com/Z-Wave-Me/home-autom ... json#L5705

Postfix can be added in Expert Mode (enable Debug mode in Controller Info tab) or push your postfix to this file (we accept Pull Requests!)