Can't trigger Aeotec Alarm 6
Posted: 25 Aug 2019 14:34
Hello, neighbours and friends...
I have been using a Raspberry pi 3 + Razberry for a while. Recently I updated to 3.0.0, and as it went wrong, I completely uninstalled it and reinstalled from scratch and everything went fine that time.
In my config a Only had a Door Sensor (Aeotec) and a fire alarm (Fibaro), and both work great (I guess Fibaro sensor works great, although it was never triggered).
Recently I bought the Aeotec Alarm 6, and I included in my z-wave network like a charm, without any problems (S2 included).
Now I am unable to create a recipe to make the alarm sound when the door is open.
I see all the accessories in the "elements" view, but when I create a IF/THEN Recipe I can use the door sensor open in the IF part, but only can Send Notification by e-mail in the THEN part. The alarm accesorio is shown in the IF part as binary sensors which they are not...
Any clue on this?
Thanks in advance
I have been using a Raspberry pi 3 + Razberry for a while. Recently I updated to 3.0.0, and as it went wrong, I completely uninstalled it and reinstalled from scratch and everything went fine that time.
In my config a Only had a Door Sensor (Aeotec) and a fire alarm (Fibaro), and both work great (I guess Fibaro sensor works great, although it was never triggered).
Recently I bought the Aeotec Alarm 6, and I included in my z-wave network like a charm, without any problems (S2 included).
Now I am unable to create a recipe to make the alarm sound when the door is open.
I see all the accessories in the "elements" view, but when I create a IF/THEN Recipe I can use the door sensor open in the IF part, but only can Send Notification by e-mail in the THEN part. The alarm accesorio is shown in the IF part as binary sensors which they are not...
Any clue on this?
Thanks in advance