App for Fibaro switch

This is a collection of wishes and needs for the next versions of Z-Way/Z-Cloud/Z-Box
Post Reply
Christian12
Posts: 33
Joined: 06 Jan 2016 10:00

App for Fibaro switch

Post by Christian12 »

That switches can be activated with alarm sequences, an app to send out wich alarm should the switch act would be nice.

in ExpertUI Options but i don't know how to send Alarmmodes to actor:

Nº 30 - General Alarm Set - Relay 1
Deactivated, devices does not react to alarms
Disable on Alarm - will switch off in case of alarm
Enable on Alarm - will switch on in case of alarm
Flashing on Alarm - will switch on and off periodically for 10 minutes
Updated: 07.01.2016 | Set value: 3 | Default value is: Flashing on Alarm - will switch on and off periodically for 10 minutes

This defines the behavior of relay 1 in case of general alarms

Save this parameter Set to default
Nº 31 - Flood Alarm Set - Relay 1
Deactivated, devices does not react to alarms
Disable on Alarm - will switch off in case of alarm
Enable on Alarm - will switch on in case of alarm
Flashing on Alarm - will switch on and off periodically for 10 minutes
Updated: 07.01.2016 | Set value: 2 | Default value is: Enable on Alarm - will switch on in case of alarm

This defines the behavior of relay 1 in case of flood alarms

Save this parameter Set to default
Nº 32 - Smoke Alarm Set - Relay 1
Deactivated, devices does not react to alarms
Disable on Alarm - will switch off in case of alarm
Enable on Alarm - will switch on in case of alarm
Flashing on Alarm - will switch on and off periodically for 10 minutes
Updated: 07.01.2016 | Set value: 3 | Default value is: Flashing on Alarm - will switch on and off periodically for 10 minutes

This defines the behavior of relay 1 in case of smoke alarms

Save this parameter Set to default
Nº 33 - Temperature Alarm Set - Relay 1
Deactivated, devices does not react to alarms
Disable on Alarm - will switch off in case of alarm
Enable on Alarm - will switch on in case of alarm
Flashing on Alarm - will switch on and off periodically for 10 minutes
Updated: 07.01.2016 | Set value: 1 | Default value is: Disable on Alarm - will switch off in case of alarm

This defines the behavior of relay 1 in case of temperature alarms

Save this parameter Set to default
Nº 39 - Active flashing alarm time

Updated: 07.01.2016 | Set value: 600 | Default value is: 0

Defines how long a alarm shall be active

Save this parameter Set to default


A App wich reports Sunrise and sunset were nice, too.

At the moment, i don't see, that razberry is the gateway, wich can act with all devices and is very tricky do configure
Post Reply