Hello,
Testing the Z-Uno on the Wink Hub 2. I programmed the Z-Uno using the "ControlRelay" example and then put my Wink Hub 2 in Inclusion Mode and then pressed BTN 3x. But nothing happens. I also tried adding a generic light on the Wink Hub but no success.
Any recommendations on what I can try to get it to work?
Wink Hub 2 - Cannot Pair
-
- Posts: 2
- Joined: 27 May 2018 04:21
Re: Wink Hub 2 - Cannot Pair
Disregard. Works on Wink Hub 2. Didnt have the Frequency set properly.
-
- Posts: 1
- Joined: 21 Jun 2018 04:18
Re: Wink Hub 2 - Cannot Pair
I am trying to pair my Z-Uno with my Wink 2 hub. Could you please reach out to me to let me know how you achieved this. I have been trying for days.
Thank you
Steve
chipconnect1@gmail.com
Thank you
Steve
chipconnect1@gmail.com
Re: Wink Hub 2 - Cannot Pair
Any update on this? I have also been trying for days to pair. I am using the binary switch example and my wink 2 hub will not recognize the Z-Uno.
I have the frequency set to USA when I upload the sketch. I have tried using inclusion mode and the "Add Product" with "Generic A-Wave Binary Switch".
Is there any way to check what the frequency of my hub is set to? I am only assuming its USA because that's where I live. It works with all of my other z-wave devices.
I have the frequency set to USA when I upload the sketch. I have tried using inclusion mode and the "Add Product" with "Generic A-Wave Binary Switch".
Is there any way to check what the frequency of my hub is set to? I am only assuming its USA because that's where I live. It works with all of my other z-wave devices.
Re: Wink Hub 2 - Cannot Pair
Try to disable Security, set USA, disable MultiCommand.
We have never tried Wink, but with simple sketch it should work out of the box.
Try to exclude first
We have never tried Wink, but with simple sketch it should work out of the box.
Try to exclude first