Z-UNO and Fibaro Wall Plug FGWPE no inclusion...
Posted: 02 Dec 2017 12:15
Hi,
I am new to program Z-UNO but confirmed in Arduino ^^
I just program my Z-uno with several exemples and I wanted to try the "Battery Power wall switch"
I bought a module from Fibaro call Wall Plug FGWPE and put it to inclusion mode.
On Z-uno everything compile and upload with the 1.6.5 IDE on my MAC, I just changed the Frequency to "Europe".
When I try to press three times the button, I can see a red LED blinking on the board, but nothing happen on the Wall Plug...
I tried with other exemple program and nothing as well..
The inclusion is fully independent from the Arduino sketch right? Is this could be from a "profile" problem?
Any ideas?
Thanks
I am new to program Z-UNO but confirmed in Arduino ^^
I just program my Z-uno with several exemples and I wanted to try the "Battery Power wall switch"
I bought a module from Fibaro call Wall Plug FGWPE and put it to inclusion mode.
On Z-uno everything compile and upload with the 1.6.5 IDE on my MAC, I just changed the Frequency to "Europe".
When I try to press three times the button, I can see a red LED blinking on the board, but nothing happen on the Wall Plug...
I tried with other exemple program and nothing as well..
The inclusion is fully independent from the Arduino sketch right? Is this could be from a "profile" problem?
Any ideas?
Thanks