forum

I know, its an old corny joke.

I have a Zuno board that I would like to place on a Perma-Proto board.

In order to no damage the Z-uno chip by soldering, I would like to use an IC socket and solder it to the board, and insert the Z-uno into the socket.

But I am having a hard time locating a 30 pin IC DIP socket.

Any recommendation ?

Thanks Guys

Dom

Just get two single row sockets and place them the correct width apart on the PCB.

Something like this (would need to be cut to size):

https://www.digikey.com/product-detail/ ... ND/5978200