Page 1 of 1

Even parity for UART

Posted: 11 Feb 2018 05:59
by risca
Hello,

I have an application that requires 8E1, i.e. even parity, to communicate. Is it possible to configure Serial0 or Serial1 for even parity?

Best regards
// Patrik

Re: Even parity for UART

Posted: 17 Feb 2018 17:57
by PoltoS
No, only 8N1 is supported

Re: Even parity for UART

Posted: 23 Feb 2018 02:13
by risca
Ok. I've ordered a SPI-UART bridge that should solve this. I'll see when it arrives.