HELP - cannot re-include z-uno
Posted: 24 Dec 2018 02:25
Hello everybody
I have been working with th z-uno for some time now.
Firmware version is 2.1.4.
IDE Version is 1.8.5
After a forced exclusion on the controller (without the z-uno entering exlusion mode) I am unable to re-include the z-uno.
I have tried rescue mode and also holding the 'service' button for 5 seconds and than clicking it 3 times.
I have uploaded the RadioBlink example afterwards to make sure it's not to do with my code - still no inclusion
Is there a way to reset the z-uno completely or is this a hardware failure?
I have been working with th z-uno for some time now.
Firmware version is 2.1.4.
IDE Version is 1.8.5
After a forced exclusion on the controller (without the z-uno entering exlusion mode) I am unable to re-include the z-uno.
I have tried rescue mode and also holding the 'service' button for 5 seconds and than clicking it 3 times.
I have uploaded the RadioBlink example afterwards to make sure it's not to do with my code - still no inclusion
Is there a way to reset the z-uno completely or is this a hardware failure?