Can't pair Aotec Key Fob remote

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
Post Reply
sil
Posts: 20
Joined: 09 Oct 2018 12:35

Can't pair Aotec Key Fob remote

Post by sil » 06 Feb 2019 20:16

Hi,

I want to use Keyfob as primary controller (this remote can be a primary controller) with ZUNO using ControlRelay example

Unfortunately I can't pair the device.
I reseted the remote (20s press on rear switch Mode) and ZUNO.
During pairing the ZUNO led blinking red and green for 35seconds.

After that putting remote into User mode but no switching on Zuno.

On Zuno side how to know if the pairing is ok ? On the remote I should see led green flashing once slowly. But it's never the case

What do I wrong???

Thanks for your help

Regards

User avatar
PoltoS
Posts: 4472
Joined: 26 Jan 2011 19:36

Re: Can't pair Aotec Key Fob remote

Post by PoltoS » 07 Feb 2019 02:39

Check frequency in Z-Uno (select the correct in the IDE).

On success it shines green.

sil
Posts: 20
Joined: 09 Oct 2018 12:35

Re: Can't pair Aotec Key Fob remote

Post by sil » 07 Feb 2019 12:36

Thanks Polto! I fell for the default frequency!

Now it works but only once. But only from off to on. (I inverted HIGH and LOW)

[

Code: Select all

  if (newValue > 0) { // if greater then zero
    digitalWrite(LED_BUILTIN, LOW);
  } else {            // if equals zero
    digitalWrite(LED_BUILTIN, HIGH);  // turn the LED off by making the voltage LOW
  }
Why toggling is not working ???

Thanks

User avatar
PoltoS
Posts: 4472
Joined: 26 Jan 2011 19:36

Re: Can't pair Aotec Key Fob remote

Post by PoltoS » 11 Feb 2019 05:42

Make sure to save the new value and report it in the getter. It might be that the remote bus checking the status prior to sending an action

sil
Posts: 20
Joined: 09 Oct 2018 12:35

Re: Can't pair Aotec Key Fob remote

Post by sil » 11 Feb 2019 22:34

Thanks.
But do you have an example ?

Post Reply