I have developed a pollution sensor, which has 4 channels ;
- Temperature : length of 1 byte ranging from -40 to +125 °C
- Relative Humidity : length of 1 byte ranging from 0 to 100 %
- PM10 concentration : length of two bytes ranging from 0 to 1000 µg/m3
- PM2.5 concentration : length of two bytes ranging from 0 to 1000 µg/m3
Code: Select all
ZUNO_SETUP_CHANNELS(
ZUNO_SWITCH_BINARY(getterSwitch1, setterSwitch1),
ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_RELATIVE_HUMIDITY, SENSOR_MULTILEVEL_SCALE_PERCENTAGE_VALUE, SENSOR_MULTILEVEL_SIZE_ONE_BYTE, SENSOR_MULTILEVEL_PRECISION_ZERO_DECIMALS, humidityGetter),
ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_TEMPERATURE, SENSOR_MULTILEVEL_SCALE_CELSIUS, SENSOR_MULTILEVEL_SIZE_ONE_BYTE, SENSOR_MULTILEVEL_PRECISION_ZERO_DECIMALS, temperatureGetter),
ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_GENERAL_PURPOSE_VALUE, 1, SENSOR_MULTILEVEL_SIZE_TWO_BYTES, SENSOR_MULTILEVEL_PRECISION_ZERO_DECIMALS, pm10Getter),
ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_GENERAL_PURPOSE_VALUE, 1, SENSOR_MULTILEVEL_SIZE_TWO_BYTES, SENSOR_MULTILEVEL_PRECISION_ZERO_DECIMALS, pm25Getter)
);
So far only the Temperature & Relative Humidity are visible and correctly updated as Domoticz devices :
I have read in several threads about the missing support of Multichannel sensors in Domoticz, however I think there is a way to modify the existing ZUno.xml description file to make the missing channels appear as devices in Domoticz, do you think it is possible ?
If not, what alternative method could I use to get the values of the 4 channels ? I was thinking about the OpenZWave JSON API maybe ?
For information under Jeedom and Z-Way servers (
Best Regards,
Benoît.
(*) Edited for correctness following to remark.